Mark the centre of the beam and measure to the centres of the pre-drilled fixings.
Mark the centre of the wall where you want to place the shelf or mantel and transfer the measurements onto the wall.
Using a nail punch, mark accurately where you would like to drill.
Place the spirit level above the drill holes and ensure they are perfectly level.
Using a 8mm drill bit and keeping the drill straight and level or slightly angled downward, drill a 80mm deep hole into each of your bracket markings on your wall.
Tap the Rawl plugs provided into the holes until they are flush to the wall.
Using a screwdriver, screw the screw provided into the Rawl plugs.
Place your beam onto the screws. Please adjust the screws so that your beam is able to sit tight to the wall.
Place the spirit level again on the shelf / beam and ensure a final level installation.
Step back, appreciate your hard work and your beautiful new beam!